Open.HD AiO AirPi
After having studied the Open.HD GitHub and forums and having tinkered around with all the needed hardware, I decided to design my own AirPi (air side module) the most compact I could.
I used Catia for that matter. For a good design without much flaws, I created the catparts of the elements to be embedded inside the case.
I ended up with a 7.5 cm long case that holds everything together and is purely independent since a 2S Li-Ion INR14500 1000 mAh battery is included inside.
The prints, apart from having some defects due to excessive hang angle, were quite good for the purpose.
A full Catia product of all components has been done prior to the fabrication to minimize possible errors. Thanks to that, the installation of all the internal components was easy.